SIP SILO 80 D, Manual, Page: 39 / 80

35
PERIODI Č NI PREGLEDI
Rok za temeljit periodi
č ni pregled za
enovrstni silokombajn SILO 80 D je eno leto.
Pregled obsega:
y
Kontrola obrabe ter privitosti lopatic,
nožev rezalnika, spodnjega noža, krožnih
nožev ter protinoža.
y
Mazanje zobnikov med bobnama ter v
zobniškem gonilu.
Ob
č asni periodi č ni pregledi med delom so po
potrebi.
Pregled obsega:
y
Kontrola privitosti vijakov in matic.
y
Kontrola napetosti klinastih jermenov.
y
Brušenje ter nastavitev zraka med noži
rezalnega koluta in protinožem.
y
Kontrola obrabe brusa.
y
Nastavitev dletastega noža do krožnih
nožev.
y
Mazanje drsne jermenice na gredi
rezalnega koluta ter mazanje ostalih
elementov po navodilih za vzdrževanje.
y
Pregled brezhibnosti zaš č it kardanske
gredi.
PERIODICAL CHECK-UPS
The one row maize chopper must be
completely checked up at least once a year.
Check-up includes following points:
•
Check the usage and tightness of
spades, blades, lower blade, oval blade
and counter blade.
•
Check the level of grease between the
drums and the gearing.
If needed, check the machine occasionally
during the working season.
Check-up the following points:
•
Check the tightness of screws and nuts.
•
Check the V-belt tension.
•
Sharpen the blades and adjust the air
between the disc blades and the
counter blade.
•
Check the grinding stone.
•
Adjust the chisel blade to oval blades.
•
Grease the pulley on the cutting disc
shaft and other part following the
maintenance instructions.
•
Check the P.T.O. shaft protection.
DOBAVE PO ŽELJI
Za traktorje, na katerih se priklju
č ne gredi
vrtijo z ve č kot 620 vrt/min. morate obvezno
namesto klinaste jermenice 455.01.014.0
(Ø 385) montirati klinasto jermenico
455.01.027.0 (Ø 335) zato, da kolut z noži
ne prekora
č i dovoljenega števila vrtljajev.
Zgornje dovoljeno število vrtljajev na
priklju
č ni gredi traktorja je za klinasto
jermenico 455.01.027.0, 720 vrt/min.
Jermeni so v obeh primerih isti.
Å
Elementi daljinskega vodenja z vle č no
potisnim bovdenom (glej sliko 11– katalog
rezervnih delov).
RQUESTED DELIVERY
Tractors with more than 620 rpm P.T.O. shaft
must replace the V-belt pulley 455.01.014.0
(Ø 385) with the V-belt pulley 455.01.027.0
(Ø 335) so that the chopper does not exceed
the allowed disc rotations.
The V-belt pulley 455.01.027.0 is for the 720
rpm P.T.O. shaft only.
The belts are the same in both cases.
Å
Parts of remote control with the wire (see
pictures 11 – spare parts catalog).