Adjustments
Height Adjustment:
To adjust up or down, loosen the clamp bolt then adjust the table to your desired position by turning the table
bracket handle.
Tilting Adjustment: (If applicable)
Loosen the table bevel lock bolt with adjustable wrench. Tilt table to desired angle and retighten the bolt.
Swing 360 degrees:
Loosen clamp bolt then swing table to appropriate position and retighten clamp bolt.
Feed Depth Adjustment:
Depth control scale sleeve type loosen the clamp bolt and move to the desired depth then retighten the clamp
bolt.
Quill Spring Adjustment:
Move the stop nuts to lowest position and lock in place with wrench to prevent quill dropping while tensioning
spring.
Place screwdriver in lower front notch (A) of spring cap (B) and hold it in place while loosening and removing nuts.
Carefully turn screwdriver counter clockwise and engage next notch. Fig. 15.
Tighten inner nut (C) with wrench. Do not over tighten, as this will restrict quill movement.
Move stop nuts to highest position and check tension while turning feed handle. If there is not enough tension on
spring, repeat steps A - D.
Check the quills while feeling for smooth and unrestricted movement, if movement is too tight, slightly loosen nuts
until unrestricted.
10
C
B
A