SIP 06434, Instructions For Use And Maintenance Manual

Page: 5 / 21

5
Before replacing the applicator (coil), disconnect 06434 from the power source (wall outlet).
If you are not using 06434, unplug the power cord from the outlet.
CAUTION
This product is for Class A industrial use. It may cause radio interference in
residential, commercial and light industrial environments. This product is not
intended for installation in residential environment, business environment and light
industry with connection to the public supply network; user may be required to take
adequate measures to reduce interference.
4.4 Fire safety rules
Do not heat aerosol or other cans, metal containers, and any pressure vessel used
for the storage of fuel, compressed gases and liquids. The heat generated by heating
06434 may cause them to explode and their contents may ignite.
Do not use the heating spiral (coil), if the insulation is damaged. A defect in the insulation may cause
sparks in contact with metal objects or between the turns of the coil. In particular, when working on
/ or near gas pipes and / or gas tanks it may pose a danger of explosion or fire. Using coils with
damaged insulation will void the warranty.
4.5 Safety rules for using the device
Do not leave 06434 uncontrolled when it is started. Always use the main switch to t urn 06434 off if
it is not used for heating!
Make sure that the power supply unit and the handle has an adequate supply of air for cooling. Make
sure the vents are clean and free of dust and dirt not to impede the flow of cooling air.
Do not attempt to repair 06434. The device does not contain any user-serviceable components,
except for replaceable heating coils.
Before connecting 06434 to the wall outlet make sure the outlet voltage corresponds
to the voltage on the rating plate. If the wall outlet voltage does not match the
voltage indicated on the rating plate, it may result in a serious risk of damage to
06434.
Do not exceed the operating cycle 06434 – 2 minutes heating (on) a 2 minutes
cooling (off). The main equipment is protected against device overheating, but
heating coils are not, which may cause their damage.
EXTENSION CORDS:
Extension cords – if necessary, you may use only the following extension cords:
up to 5m with 2.5 mm
2
diameter
up to 15m with 4 mm
2
diameter