SIP 06434, Instructions For Use And Maintenance Manual

Page: 12 / 21

12
4. Usage of an inappropriate extension cable (too long, small diameter of wires) can cause
insufficient power of the device - see the safety regulations.
5. In case of other problems contact your supplier.
9 Storage and maintenance
9.1 Cooling, dismantling and storage
After completion of heating, make sure that the coil holder and coils used are placed in a safe place.
Handling the device or its parts before letting it cool down can result in injury, damage to the
equipment or fire.
After completion of heating, leave the device turned on for 10 more minutes – the device will be
cooled down by fans until cooled off completely and then will turn off the fans. Then shut it down by
the main power switch and disconnect it from the power supply.
If you unplug the unit immediately, let all working coils cool down for at least 15 minutes.
After cooling, place the device and its accessories in the case. Place the cords so as to avoid their
sharp bending or twisting – it could cause their damage.
9.2 Proper cleaning and maintenance
Make sure the device is turned off, unplugged and cooled. Use a dry, clean cloth or paper towel to
remove grease, oil and other impurities from the machine, applicators and cables before placing
06434 in the storage case.
Use freely available non-volatile cleaning agents for grease, oil and dirt that is difficult to remove.
Before the first reuse of 06434 allow all components to air dry.
Do not immerse any part of the device in water or other liquids. Do not spray and wash the device
down with water spray. Do not clean the components with volatile organic compounds such as
gasoline, benzene, kerosene, methyl ethyl ketone (MEK), fuel oil, brake parts cleaners, paint and
thinner remover, varnish removers, self-adhesive solvents, etc. These substances cause fire and
cause hardening or dissolving of polymeric materials used in the device.
Do not use heat sources, heaters, burners, microwave ovens or gas furnaces, etc. for drying the
device and its parts after cleaning.
10 Warranty
1. Machine warranty period is determined by the manufacturer for 12 months from the sale of
machinery buyer. Warranty period begins on the date of delivery of the machine to the
purchaser, or the possible delivery date. The warranty period does not cover expendable
parts – coils. Warranty period does not include the period from the application of a
legitimate complaint until the machine is repaired.