SINTES
16
ULTRAPEEN
6. SYSTEM OPERATION RULES (continued)
6.3 . OPERATION ORDER
6.3.1 Set Mains Power Switch
Power
to OFF position.
6.3.2 Install the required working head with strikers.
6.3.3 Plug power supply unit cable into the unit and Mains Power Supply 110-
120 VAC, 60 Hz or 220-240 VAC, 50 Hz (depending on design of
Generator and local power supply standards)
.
6.3.4 Switch to ON the power switch
Power
. Indicators
Set Range
and
Select
/
Set
are illuminated.
6.3.5 Press and hold the
Control
button for 3 – 5 seconds. This will start
oscillation of Tool. If
Control
indicator illuminates in green (after 1-2
seconds in red) – the system is in working condition, if in red permanently
during pressing of the
Control
button – system is not ready for operation.
In last case, adjustment or repair of system is required and could be done
by Manufacturer of the equipment.
6.3.6 Set the level of ultrasonic energy with
Set Range
button:
1
- minimum
level;
2
and
3
- intermediate levels;
4
- maximum level.
6.3.7 Required operation time may be set by
Select
/
Set
buttons. During the
setting the digits on the indicator will flash.
6.3.8 Switch ON the ultrasonic oscillation of the Tool by
Start/Stop
button. The
Status
indicator starts to flash, and the operation time digits on the timer
illuminate continuously.
