Singer Inspiration 4205, Service Manual

Page: 25 / 42

Singer Inspiration 25
Setting
Feed dog height
Check
1. Make sure the feed dog is up.
2. Set the stitch lenghts to 5..
3 . The top of feed dog must be from 1,0 to 1,2 mm above the top surface of
the needle plate.
Adjustment
1. Set the feed dog at its highest position
2. Loose the screws (a) just lightelly.
3. By means of an open end wrench, rotate the eccentric hinge stud (b) left or right to raise or
lower the feed dog.
NOTE! The highest point of eccentric hinge stud (c) must be to the right before making the
adjustment.
4. Hold the eccentric hinge stud (c) with the open wrench while tighten screws (a).
Other wise it may cause the feed lifting lever (b) to raise slightly thereby causing the feed dog
to be slightly higher.
5. Check so there is no looseness or binding of feed lifting lever.