Chapter 2. Installing and Set Up
2-6
Setting Ink Ribbon
Transporting the Printer
1. Set the ink ribbon to the
Front Cover
as shown
3. Close the Front Cover.
When close the Front Cover, press on the
center.
In case that both the paper and the ink
ribbon are loaded into the printer and the
Front Cover is closed, initialization starts
and several sheets of paper are ejected
automatically.
2. Take the slack the ink ribbon by turning
the ink ribbon supply core.
4.Insert the claw of the dust box first and
insert the projected section of the printer in
the hole at the bottom of the dust box.
Caution: Close the Front Cover
carefully so as not to catch your
fingers.
Do not close the Front Cover quickly.
The following cautions are necessary in
transportation of the printer.
Since an incorrect transportation method
causes a printer fault, follow the correct
method.
1. Remove the ink ribbon and paper from
the printer before transporting the
printer.
If the ink ribbon or paper cannot be
removed due to a fault, consult with the
distributor.
2. Use a genuine box.
If the box used at the purchase cannot
be used, consult with your distributor
and purchase a new box.
Caution: The dust box is not set
correctly if there is a gap between the
front cover and the dust box.
OK ×
