Chapter 2. Installing and Set Up
2-5
Loading Paper
Caution:
The paper is not set correctly if
the PAPERSET Lamp is flashing in red.
Please pull out the paper until the
PAPERSET Ramp turn off.
2. Pull the lever to open the Front Cover.
4. Set the paper in the printer.
After setting the paper, remove the seal
from the paper.
Turn on the power of the printer by
pressing "|" on the power switch.
3. Install the paper flange in the paper roll
while holding down the knob on the paper
flange.
Attention: Do not open the Front Cover
quickly or with unnecessary force.
Do not press the Front Cover or place a
heavy object other than paper after opening
the Front Cover.
Caution: The paper is not set correctly if
there is a gap of about 10mm between
the paper flange and paper.
5. Insert the edge of paper under the guide
roller by rotating the paper flanges.
Insert the paper until the PEPERSET Lamp
is lit in blue.
CAUTION: Do not release the hand’s hold
from the Front Cover until the Front
Cover is opened fully.
If the hand’s hold is released while the
Front Cover is opened, there is a
possibility that the printer falls down.
1.
In case that trim dusts are stacked in the
dust box, make sure to throw them away.
