Sinclair S-THERM GSH-100ERB, Service And Installation Manual, Page: 72 / 153

Control
Page 65 Total 145
response to any touching operation except the ON/OFF operation, with a window popping up, saying
“
The force-mode is running
!”. In this case, by touching ON/OFF, “
Force mode
” will quit.
[Notes]
●This function is allowed only when the unit has just repowered and not turned on. For the unit which
once has been put into operation, this function
is unavailable, alerting “
Wrong operation!
”.
● It will not be memorized upon power failure.
3.2.4.13 Gate-Ctrl.
[Operation Instructions]
★
At the commissioning parameter setting page, by touching “
Gate-Ctrl.
”, the control panel will access
to the corresponding setting page.
[Notes]
●When “
Gate-Ctrl.
” has been activated; the display panel will detect the card state. When the card has
inserted, the unit will run normally. When the card is drawn out, the controller will turn off the unit at
once and back to the homepage. In this case, all touching operation become ineffective, and a prompt
dialog box will pop up. The unit will resume normal operation until the card has inserted back and the
ON/OFF status of the control panel will resume to that before the card is drawn out.
●This setting will be memorized upon power failure.
3.2.4.14 Current Limit/Power Limit
[Operation Instructions]
★1
. At the commissioning parameter setting page, by touching “Current limit”, it can be set to “On” or
“Off”.
★2
. When
it is set it “Off”, current limit and power limit both cannot be set. When it is set to “Current limit”
or
“
Power limit”, they can be set.
★3
. After that, this setting will be saved by touching the “Save” icon.
[Notes]
● This setting will be memorized upon power failure.
3.2.4.15 Address
[Operation Instructions]