Install of The Compact Panel Cassette Type Indoor Unit
2
Install of The Compact Panel Cassette Type Indoor Unit
★
Schematic diagram of installation spaces
≥1800
≥1500
≥1500
Model
H
260
unit:mm
>20
Wall
surface
Wall
surface
Wall
surface
Ground
surface
H
MC-C12AI, MC-C18AI
Fig.1
★
Select install location of the indoor unit
1. Obstruct should put away from the intake or outlet vent of the indoor unit so that the airflow can be
blown though all the room.
2. Make sure that the installation had accord with the requirement of the schematic diagram of installation
spaces.
3. Select the place where can stand 4 times of the weight of the indoor unit and would not increase the
operating noise and oscillate.
4. The horizontally of the installation place should be guaranteed.
5. Select the place where easy drain condensated coagulated water, and easy connect with outdoor unit.
6. Make sure that there are enough space for care and maintenance. Make sure that the weight between
the indoor unit and ground is above 1800mm.
7. When installing the steeve bolt, check if the install place can stand the weight 4 times of the unit’s. If
not, reinforce before installation. (Refer to the install cardboard and find where should be reinforced)
Note!
There will be lots of lampblack and dust stick on the acentric, heat exchanger and water pump in dining
room and kitchen, which would reduce the capacity of heat exchanger, lead water leakage and abnormal
operation of the water pump.
The following treatment should be taken under this circumstance:
1. Ensure that the smoke trap above cooker has enough capacity to obviate lampblack to prevent the
indraft of the lampblack by the air conditioner.
2. Keep the air conditioner far from the kitchen so that the lampblack would not be indraft by the air
conditioner.
★
Important notice:
◆
To guarantee the good performance, the unit must be installed by professional personnel according
with this instruction.
◆
Please contact the local special nominated repair department before installation. Any malfunction