Sinclair ASH-09AQ, User Manual

Page: 10 / 25

Maintenance
◆
▲
Turn off the unit and take out the power plug before cleaning the unit, or
▲
Don't make the unit wet, or electric shock may occur, ensure that the unit
would not be washed by water under any circumstance.
▲
Volatile liquid like thinner or gasoline would damage the appearance of the
unit (Only adopts soft dry cloth and wet cloth moisted with neuture cleaning
Take off and clean the panel
1. Take off the panel by pulling the grooves of both
ends to the shown position in figure at the same
2. Clean
3. Install panel
Insert the supports on 2 ends of panel into groove,
and put the mid rotating shaft in groove, cover
the panel cover according to arrow direction and
Clean air filter (Once about 3 months)
If the usage environment of the unit has lots of duct, the cleaning of air filter should
1. Take off air filter
Pull out the panel to an angle at both grooves on
panel forcibly at the same time, then pull the air
filter downward to take it off. As shown in right
Clean it by soft brush, water and neutral cleaning
fluid, then swing water or dry it (Note: Take off
LCD box before cleaning panel to prevent
damaging the box by water leakage. Don't
water it by hot water whose temperature is higher
than 45
℃
to prevent fade or deformation).
（ａ ）
（ｂ）
electric shock may occur.
fluid to clean appearance of the unit.)
time by the arrow direction.
cover it well.
be more frequently.
figture.
－ ８ －