![background image](http://html.mh-extra.com/html/simu/smt5hz08/smt5hz08_original-instructions-manual_1279451009.webp)
<
≥
6.2- Validate the operation from the new transmitter you
want to program:
- Press the
PROG
key of the transmitter for about
1 second
.
The motor will run for 0,5 second in one direction, then in
the other.
6.1- Open the memory of the receiver from the control
transmitter:
- Press the
PROG
key of the transmitter for about
3 seconds.
The motor will run for 0,5 second in one direction, then in
the other.
Programming a new (individual, group or main) control point:
6
Recording / controling / deleting intermediate position
7
Recording:
- Position the motor on the wanted
position.
- Press
5 seconds
on the
"STOP"
key. The motor will run for 0,5
second in one direction and then in
the other.
Deleting:
Position the motor on the intermediate position. Press 5 seconds on the "STOP" key, the intermediate
position is deleted.
Controling:
- Press on the
"STOP"
key
for
0.5 s
. the motor goes to
the intermediate position.
- For group controls, repeat operations
6.1 and 6.2 for each motor in the group.
- For main controls, repeat operations
6.1 and 6.2 for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations
6.1 with a programmed transmitter, then
perform the operation
6.2 with the transmitter to be deleted.
4/5
1- Position the motor on the
DOWN end limit
previously set in §4.3a with the "DOWN" key.
2- Press simultaneously for
5 seconds
the
"UP"
and
"DOWN"
keys, The motor will run for 0,5 second in
one direction and then in the other direction.
3-
Adjust the new position
with the
"UP"
and
"DOWN"
keys.
4- Validate the new position by pressing
2 seconds
the
"STOP"
key. The motor will run for 0,5 second in one
direction and then in the other direction.
The new end limits setting is memorized.
8.2- Re-adjustement of DOWN end limits:
1- Position the motor on the
UP end limit
previously set
in §4.3b with the "UP" key.
2- Press simultaneously for
5 seconds
the
"UP"
and
"DOWN"
keys, The motor will run for 0,5 second in
one direction and then in the other direction.
3-
Adjust the new position
with the "UP" and "DOWN"
keys.
4-
Validate
the new position by pressing
2 seconds
the
"STOP"
key. The motor will run for 0,5 second in one
direction and then in the other direction.
The new end limits setting is memorized.
8.1- Re-adjustement of UP end limits:
Re-adjustement of end limits
8
EN