2200 PRO
2200 PRO
Sun
- (automatic mode only) The sun function has the lowest priority. If the measured light level
exceeds the programmed light threshold for longer than the sun down delay time and the 2200 thinks
the window covering is up (solid up arrow) the 2200 will lower the window covering. The sun symbol
will be displayed and the down arrow will blink, indicating an active down command. After the motor
run time has expired the down arrow will turn solid, confirming the 2200 is no longer trying to power the
motor and believes the window covering is part or all of the way down. If the light level falls below the
light threshold for longer than the sun up delay time and the 2200 thinks the window covering is down
(solid down arrow) the 2200 will raise the window covering. The sun symbol will be displayed and the
up arrow will blink, indicating an active up command. After the motor run time has expired the up
arrow will stop blinking, confirming the 2200 is no longer trying to power the motor up and believes the
window covering is all the way up. (Note, stopping the up command with the face plate switches
before the up run time has expired will cause the 2200 to think the window covering “may” still be part
way down and the sun will not cause it to lower again until the unit has received another up command
and been allowed to time out)
Face Plate Switches
- (manual mode only) Pressing the up or down face plate switch will cause the
2200 to switch power to the motor in the selected direction. The arrow will blink in the selected
direction. If the switch is held for less than 3 seconds, the 2200 will stop powering the motor as soon as
the butting is released. If the button is held for over 3 seconds, the run time will be engaged and the
2200 will power the motor to the limit in the selected direction and turn off after the run time has
expired.
1 = UP
2 = STOP
3 = DOWN
4 = SET
5 = RESET
6 = AUTOMATIC OPERATION/
MANUAL OPERATION
SELECT
6
6
5
5
4
4
1
1
2
2
3
3
SET
M
M
Note, you can always exit the programming mode by pressing the stop button (2) twice. The 2200
will display the threshold values for sun and wind, then temperature and 5 seconds later return to
normal operating mode
To enter programming mode
press the set button (4) for 3 seconds
and the programming screen (fig 1) will appear. The SET icon on the
lower left of the screen confirms you are in programming mode. One
of the icons in the lower bar will be blinking. You can move between
the icons by pressing the up (1) or down (3) buttons. Pressing the set
button (4) will let you cycle through the programable values of the
blinking icon.
Fig. 1
5
