Simrad ES 18 - DATASHEET REV C, Installation Manual

Page: 63 / 88

404770/B
61
Drawing standard
Whenever self-locking threads are required, this
is shown on the technical drawing. In the case
of tapping through holes, the arrow at the end
of the center line illustrates the screw-in direction
of the bolt.
The drawing is normally provided with the
following - or similar - text:
Drill diameters for
threads differ from standard. Self-lock taps can
be supplied by Kongsberg Maritime.
Note
Refer to manufacturer’s website for the latest
drawings and information about the self-locking
taps. The illustrations and information provided here is for reference only.
Taps
The pretension locking thread self-lock (taps) from manufacturer Emuge must be used.
Note
In case of tapping through holes it is important that the profile of the Emuge self-lock
threads is in the correct direction compared with the entering direction of the bolt.
Gauge
Use Emuge self-lock gauges. Note that the gauge must be used in the correct direction.
Transducer installation principles