Simrad AP50, Installation Manual

Page: 60 / 142

Software Set-up Procedure
20222410 / B
51
Navigate through the Installation Menu as follows:
•
Answer “Yes” to a question by rotating the course knob
clockwise.
•
Answer “No” to a question by pressing the (STBD)
button. This will allow you proceed to the next menu item.
•
Return to the previous menu item by pressing the (PORT)
button.
•
Change the selected item shown by rotating the course knob
in either direction.
•
Exit the Installation Menu by pressing STBY, AUTO or
NAV buttons.
On new installations, and whenever a junction unit or software
is replaced in an AP50 system, it is recommended that a Master
Reset be performed as described under SERVICE in the
Installation Menu (see page 81) prior to proceeding with the set-
up procedure.
Note !
If a “Change-Over” switch is installed (page 18) it must be set
to the “Auto” position, otherwise the rudder can not be
calibrated for direction and feedback signal in the Dockside
menu.
When using the Installation Menu refer to Figure 3-1
"Installation Menu Flow Chart" on page 53.
Language selection
The AP50 can present the display in eight different languages:
•
English, Deutsch, Francais, Español, Italiano, Nederlands,
Svenska and Norsk.
LANGUAGE
English
Deutsch
Francais
Espanol
Italiano
Nederlands
Svenska
Norsk
To access the language selection in the Installation Menu:
1. Answer “Yes” by turning the course knob clockwise.
2. Turn the course knob to select the language you wish to use.
3. Continue to next item in the Installation Menu by pressing the
(STBD) button or leave the Installation Menu by pressing
the
STB Y
(STBY) button.
Dockside
The following menu items are accessible and can be set up in
the Dockside Set-up Menu:
•
Master operation
•
Boat type
•
Boat length
•
(Drive unit voltage)