SimpliFire • SF-INS25, SF-INS30, SF-INS35 Service Manual • 2042-960 • 3/21
4
LED Lighting Replacement
Note:
Kit includes all three LED light strip assemblies.
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching.
2. Remove front. Refer to Front Replacement section
for details.
3. Remove glass. Refer to Glass Replacement section
for details.
4. Remove log/grate assembly. Refer to Log/Grate
Assembly Replacement section for details.
5. Remove Flame Screen. Refer to Flame Screen
Replacement section for details. Remove metal
flame panel with eleven (11) screws.
6. Remove the two metal brackets in front of rear LED
strip. Remove three (3) screws to remove metal
parts. See Figure 7.
7. Locate Lighting LED circuit input power source
connectors in rear of opening. Unplug the two
connectors and jumper wire from the three circuit
boards. See Figure 8. If epoxy will not allow
separation of the two connectors, slide the pair of
connectors off the pins of the LED circuit board.
8. Using a pliers, compress each barbed clip along
the two base LED circuit boards while lifting the
boards evenly to disengage them from the clips. See
Figure 8. Use pliers to open clips along rear LED
strip while lifting to disengage it from the clips. See
Figure 9.
9. Remove all three lighting LED circuit boards.
10. Install replacement lighting LED circuit boards into
the appliance. Fully engage all clips. See Figure 8
and 9.
11. Connect the two lighting LED power source
connectors and the jumper wire to the three LED
circuit boards.
See Figure 8.
12. Install metal brackets by attaching with three (3)
screws. See Figure 7. Install metal flame panel with
eleven (11) screws.
13. Re-install Flame Screen.
14. Re-install log/grate assembly.
15. Re-install glass.
16. Re-install front.
(LED-INS
**
)
Flame Screen Replacement
(FLAM-INS
**)
Note:
Kit includes
Plastic Flame
Screen Diffuser and Metal Flame Silhouette Panel)
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching.
2. Remove front. Refer to Front Replacement section
for details.
3. Remove glass. Refer to Glass Replacement section
for details.
4. Remove log/grate assembly. Refer to Log/Grate
Assembly Replacement section for details.
5. Remove two (2) thumb screws holding the plastic
diffuser brackets and panel in place. See Figure 5.
6
. If not replacing the Metal Flame Silhouette panel
proceed to step 10.
7. Remove the eleven (11) screws attaching the Flame
silhouette panel. See Figure 6.
8. Install the new flame silhouette panel, securing it
with the eleven (11) screws removed in step 7.
9
. Re-install plastic diffuser panel and panel brackets
and two (2) thumb screws. See Figure 5.
10. Re-install log/grate assembly.
11. Re-install glass.
12. Re-install front.
Figure 6 Flame Silhouette Panel.
Figure 5 Removal installation of Plastic Diffuser Panel
