SimpliFire • SF-INS25, SF-INS30, SF-INS35 Service Manual • 2042-960 • 3/21
6
Rotisserie Motor and Rod
1. If necessary, place a drop cloth or other material on
the hearth or flooring to prevent scratching.
2. Remove front. Refer to Front Replacement section
for details.
3. Remove glass. Refer to Glass Replacement section
for details.
4. Remove log/grate assembly. Refer to Log/Grate
Assembly Replacement section for details.
5. Remove Flame Screen. Refer to Flame Screen
Replacement section for details. Remove metal
flame panel with eleven (11) screws.
CAUTION:
Be careful of sharp edges on rotisserie.
6. Disengage rotisserie rod from motor located in right
rear of cavity. Use pliers to shift the reflector rod to
the left until the rubber coupler on the right end
disengages from the motor shaft. See Figure 12.
7. Remove metal panel on right side of cavity to allow
access to the rotisserie motor and wiring
connections. Remove screws to remove panel. See
Figure 13.
8. Remove three screws that attach motor mount
bracket to the appliance chassis and cut the wire tie.
See Figure 14.
9. Remove the motor and bracket from the chassis until
the electrical connector is visible. See Figure 14.
10. Disconnect the electrical connector to the motor. See
Figure 14.
11. Install the replacement motor on the bracket
.
12. Reconnect the electrical connector between the
motor and the appliance. See Figure 14.
13. Install the motor mount bracket to the chassis with
three (3) screws. See Figure 14.
14. Install the replacement reflector rod. Install the left
end of the rod into the bushing in the left rear of the
cavity. Align the rubber coupler with the motor shaft.
Shift the rod to the right until the rubber coupler fully
engages the motor shift. See Figure 12.
15. Reinstall metal bracket in front of motor. Install
screws to fasten the panel. See Figure 13.
16. Re-install metal flame panel.
17. Re-install log/grate assembly.
18. Re-install glass.
19. Re-install front.
(ROTISS-INS**)
Figure 12 Rotisserie Rod Removal
RUBBER COUPLER
Figure 13 Remove Panel
Figure 14 Motor Replacement
ELECTRICAL
CONNECTION
MOTOR MOUNT
BRACKET
