THREADING THE BOBBIN CASE
Hold the bobbin between the thumb and forefinger of your right
hand and pull off about 15 cm (16 inches) of thread.
1. Hold the bobbin case in your left hand as shown and place
the filled bobbin inside.
2. Pull the thread into the slot in the edge of the bobbin case.
3. Now pull the thread under the tension spring and into the
thread eyelet.
To insert the bobbin case and bobbin…..
Make sure that about 15 cm (6 inches) of thread extends
out of bobbin. Hold the bobbin case so that the long finger
of the case points up. Open the latch of the bobbin case.
Slip the bobbin case over the center pin of the hook and
press in place until the long finger of the bobbin case
enters the notch. Release the latch and press down.
Retyped by Mastersewusa.com
18
