SERVICING THE MOWER BLADES
1. Remove mower from the tractor.
2. Blades should be sharp and free of nicks and dents.
If not, sharpen blades as described in following steps.
3. To remove blade for sharpening, use wooden block
to hold blade while removing the blade mounting cap-
screw (figure 17).
4. Use a file to sharpen blade to fine edge. Remove all
nicks and dents in blade edge. If blade is severely
damaged, it should be replaced.
5. Balance the blade as shown in figure 18. Center the
blades’ hole on a nail lubricated with a drop of oil. A
balanced blade will remain level.
6. Reinstall each blade with the tabs pointing up toward
deck as shown in figure 19. Secure with a capscrew
(D), cup washer (C) and spline washer (B). Use a
wooden block to prevent blade rotation and torque
capscrews to 45-55 ft.lbs. (61-75 Nm.).
16
LOOSEN
Figure 17. Removing The Blade
Figure 18 Balancing The Blade
Figure 19. Installing The Blade
A. Wooden Block
C. Cup Washer
B. Spline Washer
D. Capscrew
WARNING
For your personal safety, blade mounting cap-
screws must each be installed with a cup washer
and spline washer, then securely tightened.
Torque blade mounting capscrew to 45-55 ft.lbs.
(61-75 N.m.)
WARNING
For your personal safety, do not handle the
sharp mower blades with bare hands. Careless
or improper handling of blades may result in
serious injury.
Normal Care
A
D
C
B
TIGHTEN
Thin Finishing Nail
