SmartPump Startup -
22
1.
Turn off the control power circuit breaker.
2.
Remove the shaft coupler guard
(if present)
from the pump (see
Rotation Sticker
).
3.
Turn on the control power circuit breaker.
4.
Press the Start Fill button. The pump should start and run.
5.
The shaft should rotate in the direction indicated on the sticke
r
on the motor (See
Rotation Sticker
).
6. If rotation is incorrect:
a. Press the Stop Fill
button.
b. Turn off the control
power circuit breaker.
c.
d.
e.
Open the Control Panel
door
to access the
control compartment.
Locate the overload relay
(See
Overload Relay
)
On either side of
the
relay, reverse
the
black and red
wires:
connect the
red wire
to line one
and the
black wire
to line two.
f. Close the Control
Pane
door
and repeat steps
3 through 5.
7.
Turn the control power circuit breaker off.
8.
Reinstall the shaft guard.
9.
Connect the outlet of the SmartPump to the
storage tank(s) using 3-inch steel or black iron
pipe.
CHECKING PUMP ROTATION
Rotation Sticker
Overload Relay
APPENDIX C - SMARTPUMP STARTUP
