6
Model 2099-9796 uses a glass pane to cover the T-handle used to activate an
alarm. Follow these steps to replace this pane. Refer to Figure 4 for an
illustration of this procedure.
1. Lift the hammer (B) to an upright position.
2. Position the top edge of the glass pane (C) under the tab on the manual
station, This tab is located at the top of the opening in which the glass pane
fits. Callout (D) in Figure 4 identifies the location of this tab.
3. Fit the bottom of the glass pane into the notch located in the glass retainer.
See (E) in Figure 4.
4. Push the glass retainer (A) into place. The tab at the end of the glass
retainer fits into a slot on the back of the manual station to hold the retainer
in place.
5. Gently lower the hammer back into place.
A
C
B
B
D
C
E
Figure 4. Replacing the Glass Pane
Continued on next page
Replacing the Glass Pane/Glass Rod
Replacing a Glass Pane
Technical Manuals Online! - http://www.tech-man.com
firealarmresources.com
