User Guide
Page 19
If you do not know whether you already have Card and Socket
Services installed and you are using MS-DOS 6 or higher with
Windows 3.x, perform the following:
1. While booting your computer, press <F8>. With MS-DOS 6 or
higher, this will load the drivers in CONFIG.SYS one line at a
time.
2. When prompted, press “Y” to load each driver and look for
messages indicating that Socket Services Release 2.1 (or
higher) and Card Services Release 2.1 (or higher) are loading.
If there are existing Card and Socket Services, proceed to
Plugging in
the Card.
If Card and Socket Services did not load, call your com-
puter manufacturer to determine if a copy of Card and Socket
Services is available for your computer.
Plugging in the Card
Refer to the section appropriate to your operating system.
!
In most computers, the Simple logo will be facing upward when
plugging the PC Card in the socket. If the PC Card doesn’t
appear to seat properly, try turning the PC Card over. Do not
force the PC Card into the socket under any circumstances.
Windows 3.x with Card and Socket Services Release 2.1 or Higher
Proceed as follows:
1. Start Windows 3.x.
2. Plug the PC Card into the PC Card socket. The computer may
beep when the computer recognizes the card.
Windows NT
Proceed as follows:
!
Windows NT does not support Plug n’ Play. You must plug the
PC Card into the PC Card socket before starting Windows NT.
1. Before starting Windows NT, plug the PC Card into the PC
Card socket.
2. Start Windows NT.
OS/2 Warp
Proceed as follows:
1. Start OS/2 Warp.
2. Plug the PC Card into the PC Card socket.
