Simpact Freeway 2000, Hardware Installation Manual

Page: 48 / 86

48 DC 900-1331F
Freeway 2000/4000 Hardware Installation Guide
You can change the default FTP user name and FTP password that Freeway uses
by changing the corresponding boot parameters on the Freeway system. If you do,
remember that you must also change the user name and password of the FTP
account on the boot server.
4. The system administrator has assigned the following device names and addresses
in the UNIX
/etc/hosts
file, the Windows NT
hosts
or
lmhosts
file, or using
your VMS TCP/IP package:
•
Freeway server name and Internet address
•
Boot server name and Internet address
•
Gateway Internet address (if applicable)
The procedure for configuring the Freeway system boot parameters is the same for
UNIX, VMS, and Windows NT systems. Freeway obtains the boot parameters from
local non-volatile memory during system boot. Therefore, when you configure the boot
parameters in the following steps, all applicable parameters must be configured.
Step 1:
Turn on the power. The power switch is located in the lower left corner of the back
panel. To turn on the power, press the rocker switch in the direction of the “|” symbol.
If your Freeway has an MVME 162 CPU board, the first LED (far left) on the front panel
should turn from red to green. (See Figure 3–3 on page 56 .) This indicates that internal
diagnostics have completed successfully. If the first LED does not turn green, check the
installation steps to be sure you have performed each step correctly. If this does not
solve the problem, contact your Simpact customer service representative at 1-800-275-
3889. Note that only the first LED is significant at this point. Depending on what soft-
ware may have been preloaded by Simpact, one or more of the other LEDs may also
turn green. This is OK. The other LEDs are used as diagnostic indicators and are
explained in Step 7 on page 54 .
The LEDs are not used for a Freeway with an MVME 2600 CPU board.