User manual - METER SWE-N55L
Connection cable
without relay
with relay
2 core cable (power supply)
4 or 5 core cable (2 power supply wires + 2 or 3 wires
for relay)
Screws tightening max. torque
0,5 Nm
Max. connection leads diameter
2,5 mm
2
EMC
according to: PN-EN 61326-1
This is a class A unit. In housing or a similar area it can cause radio
frequency interference. In such cases the user can be requested to use
appropriate preventive measures.
4.
DEVICE INSTALLATION
The unit has been designed and manufactured in a way assuring a high level of user
safety and resistance to interference occurring in a typical industrial environment. In order to
take full advantage of these characteristics installation of the unit must be conducted correctly
and according to the local regulations.
- Installation should be conducted by qualified personnel.
- Read the basic safety requirements on page 3 prior to starting the installation.
- All installation works must be conducted with a disconnected power supply.
4.1.
UNPACKING
After removing the unit from the protective packaging, check for transportation damage.
Any transportation damage must be immediately reported to the carrier. Also, write down the
unit serial number on the housing and report the damage to the manufacturer.
Attached with the unit please find:
- user’s manual,
- warranty.
4.2.
ASSEMBLY
- Disconnect the power supply prior to starting assembly.
- Check the connections are wired correctly prior to switching the unit on.
To install device on the wall, a pinholes should be made. Figure 4.1 presents
dimensions of the device and distances between holes. The back side of the device
has two mounting holes. This part of the case should be mounted to a wall by
screws.
5
!
!
!
!
Summary of Contents for SWE-N55L
Page 30: ...User manual METER SWE N55L 30...
Page 31: ...User manual METER SWE N55L 31...
