Simex PUR-49D, User Manual

Page: 33 / 80

User manual - CONTROLLER PUR-49D
Figure 6.15. An example of the progress of an OC type PWM output signal in PULS mode
7. DEVICE PROGRAMMING
The device menu allow user to set all parameters connected to operation of
measurement input, control modes, critical situations behaviour, communication via RS-485
and access settings. The meaning of the particular parameters is described in chapter
7.3. MENU DESCRIPTION .
Some of the parameters can be accessed without entering menu (quick view mode). SV
display is showing the value of chosen parameter (see chapter 7.3.10. ”diSP” menu ). By
using button [^] or [v] it is possible to view values of remaining parameters. If no button will be
pressed in 5 seconds, the device returns to showing on the SV display value of the parameter
chosen in
„diSP” menu . If a free access is enabled (see chapter 7.3.11. ”SECu” menu ),
user can change the value of relay treshhold or PID Set Point by selecting it ( [^] or [v] button)
and pressing [ENTER] button (see chapter 7.2. PARAMETERS EDITION ).
7.1. PROGRAMMING MENU
To enter main menu (being in the measurement mode) user must to press and hold
at least 2 sec. [ESC/MENU] button.
If the user password is defined (see parameter “Scod“ , menu “ SECU” ), operator have
to enter correct one before proceeding to menu options . Entering of the passwords is similar
to the edition of numeric parameters
(see chapter 7.2. PARAMETERS EDITION )
,
however
presently editing digit is showed only on the display, other digits are replaced by “-” sign. After
entering of last digit of the password first menu position will be displayed (if the password is
correct) or warning “
Err ” in other case.
Pay attention when device parameters are being changed. If it is possible, turn off
controlled installation (machine).
33
!
1
0
0 10 20 30 40 50 60 70 80
Time [s]
PEri = 200
90 100
Output
state
D= 50%
Minimal
on and off
time