Sime MURELLE HE 110 R ErP Original Instructions Manual Download Page 86

Page: 86 / 88

10 seconds if no key is pressed.

Regulation of the external sensor (fig.

25/a)

If an external sensor is installed, the value
of the output temperature is automati-
cally chosen by the system, which quickly
adjusts the environmental temperature on
the basis of the external temperature.
If you wish to change the value of the tem-
perature, increasing or decreasing that
calculated automatically by the electronic
card, proceed as indicated in the preceding
paragraph. The level of various correction
of a value of temperature proportional cal-
culated. The display will be as shown in fig.
25/a.

TO SWITCH OFF THE BOILER

(fig. 24)

In the case of a short absence, press the
key (

) of the controls (pos. 2).

The display will be as shown in the fig. 24. In
this way, leaving the electricity and the fuel
supply connected, the boiler is protected
from frost and from the pump becoming
blocked. If the boiler is not used for a pro-
longed period, it is advisable to disconnect
the electricity supply, by switching off the
main switch of the system, and to close the
gas tap and, if low temperatures are ex-
pected, to completely empty the hydraulic
circuits to avoid pipes being broken by the
formation of ice in the pipes.

ANOMALIES AND SOLUTIONS

When there is a functioning anomaly, the
display shows an alarm and the blue lumi-
nous bar becomes red. Descriptions of the
anomalies with the relative alarms and so-
lutions are given below:
–

ALARM 02 (fig. 27/a)

If the water pressure detected is lower
than 0.5 bar, the boiler will stop and the
display will show “ALL 02”.

Lower the knob and turn it anti-clockwise

to open until the pressure indicated by
the display is between 1 and 1.5 bars.

If it is necessary to repeat the system

loading procedure, it is advisable to

contact qualified technical personnel to

check the seal of the heating system (to

check whether there are any leaks).

–

ALL 03

Request assistance from qualified tech-

nical personnel.

–

ALL 05

Request assistance from qualified tech-

nical personnel.

–

ALL 06 (fig. 27/c)

Press the key

of the controls (2) to

re-start the boiler.

If the anomaly persists, request assi-

stance from qualified technical person-

nel.

–

ALL 07 (fig. 27/d)

Press the key

of the controls (2) to

re-start the boiler.

If the anomaly persists, request assi-

stance from qualified technical person-

nel.

–

From “ALL 08” to “ALL 10”

Request assistance from qualified tech-

nical personnel.

–

ALL 13 (fig. 27/e)

Press the key

of the controls (2) to

re-start the boiler.

If the anomaly persists, request assi-

stance from qualified technical person-

nel.

–

ALL 14 and ALL 15

Request assistance from qualified tech-

nical personnel.

–

“

FLASHING”

Request assistance from qualified tech-

nical personnel.

–

From “ALL 20” to “ALL 29”

Request assistance from qualified tech-

nical personnel.

–

From “ALL 30” to “ALL 35”

Request assistance from qualified tech-

nical personnel.

–

ALL 70 and ALL 71

These alarms appear on the SIME HOME

remote control display. Request assi-

stance from qualified technical person-

nel.

GAS CONVERSION

If it is necessary to change to a different
type of gas, request assistance only from
authorised technical personnel.

MAINTENANCE

Annual maintenance of the appliance
should be planned sufficiently in advance,
requesting the assistance of authorised
technical personnel.

ATTENTION: It is mandatory that the ded-

icated power cable is replaced only with

a spare cable ordered and connected by

professionally qualified personnel.

DISPOSAL OF THE EQUIPMENT

(EUROPEAN DIRECTIVE

2012/19/UE)

Once it reaches the end of its
operating life, the equipment
MUST BE RECYCLED in line
with current legislation.

IT MUST NOT be disposed of together with
urban waste.
It can be handed over to recycling centres,
if there are any, or to retailers that offer
this service.
Recycling prevents potential damage to the
environment and health. It allows to reco-
ver a number of recyclable materials, with
considerable savings in terms of money
and energy.

Apre

Circuito

riscaldamento 2

Circuito

riscaldamento 3

(impianto tre

zone)

Apre

Circuito

riscaldamento 2

Circuito

riscaldamento 3