Sime 8099157, Installation, Use And Maintenance Instructions

Page: 49 / 60

19 20127402
GB
Electrical wiring
7.5 Table of times
* independent by flame control
7.5.1 Operations status indication
7.5.2 Fault diagnostics - lockouts
Key
Symbol Description Value (sec.)
t0 Standby: the burner is waiting for a heat request -
t1 Standby time for an input signal: reaction time, control box remains in waiting mode for t1

1
t2 Initialisation standby time: check time following the main power start-up 3.5
t2l
Checks extraneous light or parasite flame during t2: waiting mode for t2l, then lockout: the motor
does not start
25
t2p Oil pre-heating time : waiting status for t2p, after goes into lockout max 600*
t3 Pre-purging time: the fan motor is working 15
t3l
Checks extraneous light or parasite flame during pre-purging: control box goes into lockout at the
end of t3l
25
t3i Spark pre-ignition time 2
ts Safety time 5
t4I Total spark ignition time 10
t4l Reaction time to achieve safety shut-down due to flame failure

1
t5i Spark post-ignition time 3
- Minimum time to reset the control box using remote reset 0.4
tr
Re-cycles: max. no. 3 repetitions of complete start-up sequence if there is a flame failure during
operation; the final action at the last attempt following flame failure is a lockout
3
re-cycles
tpp Post-purge time: additional purge time at the end of a heat request. Can be interrupted by a new
heat request
60
Status
Button colour
button
Seconds Colour code
OFF OFF - - -
Pre-heating time GREEN blinking 0.5 2.5
Pre-purge ORANGE blink 0.5 0.5
Safety time GREEN blink 0.5 0.5
Running GREEN - - Steady ON
Fault description Reset button colour Seconds Colour code
Extraneous light (false flame signal)
GREEN, RED
blinking alternately
0.5 0.5
Frequency supply error ORANGE - - Steady ON
Voltage monitor error
ORANGE, GREEN
fast blinking alternately
0.2 0.2
Reset push-button anomaly
GREEN, RED
fast blinking alternately
0.2 0.2
Lockout for no flame after TS RED - - Steady ON
Lockout for extraneous light signal or for parasite flame
RED
blinking
0.5 0.5
Lockout for maximum number of recycles (flame absence
during operation)
RED
fast blinking
0.2 0.2
Lockout for pre-heating not finished RED blinking 0.5 2.5
Lockout for fan motor error
RED, ORANGE
blinking inverted
2.5 0.5
Lockout due to fault with the internal command circuit that
manages the oil valve
RED, GREEN
blinking inverted
2.5 0.5
Lockout for eeprom error
ORANGE, GREEN
blinking alternately
0.5 0.5
ON OFF Colour code
RED
ORANGE
GREEN