13
To set an input for MOON CD:
SETUP > MOON CD > ‘Select the desired input’
Volume
Volume level setting at the moment the MOON 390 is
turned on, out of standby:
At turn on, the MOON 390 either start at the last volume
level it was before it was put to Standby, or at specific
value defined in the menu.
To set ‘power on volume’ preference :
SETUP > PWR ON VOLUME > LAST
or
SETUP > PWR ON VOLUME > SPECIFIC VALUE >
‘set the desired value’
To set a maximum volume:
SETUP > MAXIMUM VOLUME > ‘set the desired value’
This setting will limit the maximum volume
the MOON 390 can be set via its volume control. This is
useful for example if kids are present and there is fear they
might make it play too loud and damage loudspeakers for
example. Default is without limitation; maximum volume
at 80.
Screen Saver
A screen saver is implemented in the MOON 390
software to extend the life of the OLED display beyond
the life of the product. The following settings are available
to tailor the screen saver behavior:
To disable entirely the screen saver:
SETUP > SCREEN SAVER > MODE > DISABLED
To set the activation of the screen saver after twenty
minutes of silence and no user interaction:
SETUP > SCREEN SAVER > MODE > SILENCE
To set the activation of the screen saver after a period
of twenty minutes of no user interaction, even if music
is playing:
SETUP > SCREEN SAVER > MODE > USER OPERATION
To set the look of the screen saver as a MOON logo
randomly floating on the display window:
SETUP > SCREEN SAVER > LOOK > MOON LOGO
To set the look of the screen saver to a black screen:
SETUP > SCREEN SAVER > LOOK > DISPLAY OFF
Standby Mode Setting
The following settings are available to tailor the Standby
mode behavior of the unit.
To keep powered most electronics in the unit while
in Standby mode:
SETUP > POWER SETTINGS > NORMAL
To put most electronics off while in standby to draw
less mains current :
SETUP > POWER SETTINGS > LOW POWER
To automatically go in low power mode as described
above after twenty minute of silence and no user
activity:
SETUP > POWER SETTINGS > AUTO OFF
Firmware
To verify currently installed firmware version
in the unit :
SETUP > FIRMWARE > VERSION
To update the unit to newer firmware version:
SETUP > FIRMWARE > UPDATE
If you activate firmware update, make sure not to unplug
the mains or turn off the rocker switch of the unit while the
update takes place. Once the firmware update has been
completed, it is a good practice to make a power cycle
with the rocker switch on the back panel.
To reset the unit to factory settings:
SETUP > RESET
The system asks if you are sure before proceeding,
to avoid any bad surprise. Note that this will erase
any particular settings saved (including friendly name,
WiFi settings, etc) to replace with factory settings.
