Sim2 SUEPRLUMISHB, User Manual

Page: 6 / 44

•
When you no longer wish to use your electrical and electronic equipment,
take it to your local waste disposal facility for recycling.
•
You may return your old equipment to your SIM2 Authorized Dealer free of
charge when you buy a new product that is equivalent or has the same
functions as the old one. Contact SIM2 to find your local dealer.
•
If you need more information regarding recycling, reuse and product
exchanges, contact SIM2 customer service.
Lastly we suggest further measures to safeguard the environment, such as recycling of
internal and external packaging (including that used for shipping) in which the product
was delivered. With your help, we can reduce the amount of environmental resources
required to make electric and electronic equipment, reduce the use of waste tips for
used equipment and, in general, improve our quality of life by making sure that
hazardous materials are correctly scrapped. Incorrect treatment of the product at the
end of its service life and failure to follow the above disposal instructions are
punishable under local legislation.
Product disposal
The lamp inside this projector contains mercury and may be subject to
special disposal or recycle regulations. Dispose or recycle in accordance
with local laws. For more information contact the Electronic Industries
Alliance at
www.eiae.org or check www.lamprecycle.org
Notice
The appliance has been subjected to exhaustive operating tests by SIM2 to guarantee
the highest quality. The projector bulb life should thus initially be around 30-60 hours.
In addition to the customary checks, the Quality Control department also runs addi-
tional statistical tests before shipment. In such cases, the packaging may show signs of
having been opened, and the hours of lamp operation may prove to be higher than
those normally shown when only standard tests are performed.
As the optical system of the SUPERLUMIS is extremely compact and has the purpose
of developing very high brightness and contrast, it is possible that a small quantity of
light is visible outside of the projection area and will vary depending on the type of
lens used and the zoom and shift setup. This characteristic of the optical system is to
be deemed as normal. In order to reduce this effect SIM2 recommends that the area
surrounding the projection screen is as dark as possible.
The SUPERLUMIS is a three chip DLP projector and uses three high resolution DMD
(red, green, blue). These three DMD are precisely aligned through a high precision
process that reduces the alignment error to within the foreseen limits of tolerance.
The maximum limits of misalignment are the following:
•
Screen Center: up to 0.7 pixels between each color
•
Screen Borders: up to 2 pixels between each color
Important information SUPERLUMIS
User Guide
6