every attached device at the same it is connected, reducing drastically the
time required for HDMI source switching. For this reason you may note a
slight delay before the image appears on the screen, but it is perfectly normal.
•
Graphics RGB Input for Personal Computer and other sources that outputs
RGB or YPrPb signals. These sources must be able to provide separate H/V
sync or composite H+V sync.
•
RGB/YPrPb Input for DVD Players, Set Top Boxes and other sources that
output one of the following signals:
◦
Component (YPrPb)
◦
RGB with composite sync on green (RGsB)
◦
RGB with HV composite sync
RGB connectors also provides RGB input for SCART RGBS sources. See “
Video
”
below and “
RGBS Sync
” on page
30
.
•
Video This is the the input for composite video sources (such as VCR or
camcorders). This connector is also the composite sync input for SCART RGBS
sources. See “
RGB/YPrPb
” above and “
RGBS Sync
” on page
30
.
Control
You can connect the M.150S projector to a Personal Computer or a control system
through one of the following methods:
•
RS-232 port, using a standard 9-pin straight serial cable
•
RS-232 port, using a USB to serial converter cable. In this case, installation of a
device driver provided by the cable manufacturer may be required
•
USB port, using a USB Type A (rectangular) to Type B (square) cable connector.
In this case, installation of a device driver provided by SIM2 may be required –
ask your SIM2 Authorized Dealer
Note:
RS-232 communications are limited to 15 m (50 ft.), whereas USB are limited to
5 m (16 ft.).
Triggers
Some Home Theater devices can be controlled through a 12 V signal. The projector
can output three 12 V (100 mA max) signals:
•
TRIG1 for motorized screens control
•
TRIG2 and TRIG3 are for motorized screen masks and anamorphic lens motors
control. See “
Screen
”
and “
Anamorphic Lens
”
on page
28
for instructions on
how to do configure them from OSD
Note:
Three jack adapters are shipped with the projector.
3D RF Emitter
The RF emitter sends the RF pulses that sync the 3D glasses. Proceed as follows to
install the emitter:
1. Place the emitter near the projector on a secure surface or use an appropriate
mount kit. For maximum range emitter should not be placed on the ground/floor but
should be placed at least 10 cm above ground (like on a shelf).
2. Connect the emitter connector to the corresponding 3D Sync Out output connector
in the projector.
3. Once the emitter is connected to the projector, please make sure that the projector
3
Installation
M.150S
User Guide
17
