Switching On and Off
Switching On
1. Turn on the main power switch on the rear of the projector. The projector
enters the low power Standby status. The indicator light on the left hand side
of the projector turns red and the status display next to it shows
. .
2. Press any of the numeric keys (0-9) on the remote control or the I/O button
on the projector keypad to switch on the projector.
3. The indicator light turns green and red and the status display shows
88
for a
while.
4. The SIM2 logo appears on the screen within five seconds.
5. When the projector is ready for use (this can take approximately 40 seconds),
if a valid signal is detected, an image appears on the screen (otherwise a black
screen with the “No Signal
”
message is displayed).
Switching Off
1. Press and hold the Off key on the remote control or the I/O button on the
projector keypad.
The indicator light flashes green and red to indicate that the projector is
cooling down. Cooling fans remain on for approximately ten seconds to cool
the light source. In the meanwhile the projector cannot be turned on again.
2. After cooling is complete the projector enters Standby status. The status
display turns black, unless an error or warning code is displayed.
3. The indicator light turns:
•
Red if Standby Mode is set to Eco
•
Orange if Standby Mode is set to Fast Switch On
3
Installation
M.150S
User Guide
19
