CRYSTAL4-SH
User Guide
17
Custom Remotes
You can use your own IR remote control to control your CRYSTAL4-SH projector.
If you are using a remote control with learning capabilities, use the projector
remote control to teach the commands to your remote.
If you are using a programmable remote control, the setup software probably
allows importing Hex codes. See “
SIM2 NERO4 IR Control” document,
for a list of
all the projector codes.
Operation
The CRYSTAL4-SH projector has two IR receivers (A
, B) one on the front of the unit
and one on the top. The operative range of the remote control is approximately 10 m
(33 ft.) and ±15°. Make sure that there is nothing obstructing the infrared beam
between the remote control and the IR receiver you are pointing to. You can point the
remote control towards the screen, as the IR beam is reflected by the screen towards
front IR receiver of the projector. In this case the effective range of the remote control
may be smaller than declared.
Item Description
A
Front IR receiver
B
Top IR receiver
Batteries
To install batteries in the remote control:
Open the battery cover.
Insert two AAA (LR03) batteries making sure the polarities match the
+
marks
inside the battery compartment.
B
A
Summary of Contents for CRYSTAL4-SH
