Sim2 CRYSTAL4-SH, Manual

Page: 46 / 64

CRYSTAL4-SH
User Guide
46

Sleep Timer (min.) : sets the countdown timer interval. The countdown timer
will start with or without a signal being sent to the projector. The projector
will automatically power off when the countdown has finished (in minutes).
The Sleep Timer is reset every time when the projector is powered off. Range
[0 .. 990], with minimum increments step of 30 minutes.

Always On : Check to set the sleep timer always on.

Power Mode (Standby): set the power mode setting.

Active : choose “Active” to return to normal standby.
 Eco : choose “Eco.” to save power dissipation further < 0.5W.
According to the Europe Specification, the normal status of the "Power Mode"
menu is disabled, because the standby mode, with the LAN feature, should be
under 2W.
Is it possible to enable it by pressing the following buttons sequence in the
Remote Control: Power-Down-Right-Left-Down-Menu.
Security
Enable this function to prompt for a password before using the projector. Choose “On”
to use security verification when the turning on the projector. In this status appear a
quick menu to select the 4 digit password.
Choose “Off” to be able to switch on the projector without password verification.
The default Security password is “1234”.
Test Pattern
Enters internal test patterns, that are needed for installation or calibration purposes.
Select the test pattern from green grid, magenta grid, white grid, white or disable this
function (off). They are DMD's Test Patterns.
Note: OSD menus are not available while test patterns are displayed.
Remote Settings
Set the IR function setting.

IR Function : choose from which IR receivers the projector can be operated by
remote control. The projector has two receivers: top and front.
•
On : operated from top and front receivers.
•
Front: operated from the front receiver.
•
Top: operated from the top receiver.
•
Off: the projector can't be operated by the remote control, you will be able
to use only the keypad keys.

F1, F2, F3 buttons function : assign the default function for F1, F2, or F3 between
AV mute, Freeze, Test Pattern, Sleep Timer, CMS, Color Temp, 12V Trigger,
Auto Source, Aspect Ratio, DigZoomMin, DigZoomNone, Gamma, Projection, LAN