Backpacker MV
www.silverstarmobility.com
13
I V . O P E R A T I O N
BACKPACKER MV LIFT SYSTEM OPERATION
The Backpacker MV Lift System is designed to lift an unoccupied mobility device from the ground and into the
cargo area of an SUV, full-sized or mini van for the purpose of easy transport.
WARNING! The Backpacker MV Lift System is intended for the transport of unoccupied
mobility devices only. Do not sit on mobility device while activating lift or during transport.
WARNING! Make sure the lift system
is clean, dry, and free of obstructions
before operating.
Follow these steps to load a mobility device with the
Backpacker MV Lift System:
1. Press and hold the “DOWN” button.
See figure
7
. The lift will move out of the van to its farthest
forward stop, then lower to the ground. Once the
platform has reached the ground, release the
“DOWN” button.
WARNING! Release the “DOWN”
button when the lift platform touches
the ground. Do not allow the motor to
run after the lift platform has touched
the ground. Allowing the motor to run
will increase the pressure on the lift
platform and may result in product or
vehicle damage.
NOTE: The lift motor is equipped with a slip clutch,
which emits a ratcheting noise at the end of each
horizontal (in and out) movement. This sound is
normal and does not indicate a problem with your
lift system.
WARNING! Maintain a safe distance
from the lift platform. Ensure your feet
are not positioned under the lift
platform and keep your hands clear
of the lift system during operation.
2. Set the speed control to the slowest setting and care-
fully drive the mobility device onto the lift platform,
being sure to center the mobility device between the
previously installed wheel chocks.
NOTE: You may wish to load the mobility device
while standing next to it using the manual freewheel
feature. Refer to the mobility device owner’s manual
for more information on manual freewheel mode.
Figure 7. Hand Control
Figure 8. Y-Strap Positioning
