8
www.silverstarmobility.com
Backpacker MV
I I I . I N S T A L L A T I O N
BACKPACKER MV LIFT SYSTEM INSTALLATION
WARNING! The Backpacker MV Lift should be installed by an authorized service
technician only.
WARNING! At least two people should lift the Backpacker MV into the rear of the vehicle.
Use proper lifting techniques and avoid lifting beyond your physical capability.
WARNING! Avoid pinch points! Do not hold the lift frame by the pivot points when installing
the Backpacker MV.
NOTE: Use only the supplied hardware to install the Backpacker MV Lift System.
Follow these steps to install the Backpacker MV:
1. Install the Backpacker MV securement kit to the vehicle. Refer to the installation instructions supplied with the
securement system.
NOTE: Securement systems vary depending on vehicle manufacturer. Refer to the installation
instructions supplied with your securement system or contact your authorized Pride Provider for
more information.
2. Connect the Backpacker MV to a power source. See “Wiring Harness Installation.”
NOTE: If your lift is equipped with an optional onboard battery, refer to “Onboard Battery Installation.”
3. Ensure that all mounting hardware is fully tightened once the lift has been centered and all required clearances
have been achieved.
NOTE: If there is not adequate clearance between the bumper and the platform frame, you may need to
install an end support bracket. Remove the Backpacker MV from the van and install the end support
bracket close to the rear door opening. Reinstall the lift into the van, making sure that the bolts pro-
truding from the bottom plate of the Backpacker MV closest to the vehicle door snap into the tapped
holes on the top of the end support bracket.
NOTE: It may be required to trim the rear inside sill to achieve the adequate platform clearance with
the platform under load.
4. Run the Backpacker MV through an entire lift cycle. Lower the platform to the ground and then raise the
platform to the fully stowed position in the van. See IV. “Operation.”
NOTE: Ensure the transit screw and washer have been removed from the front of the lift and the rubber
bushing has been installed before operation. See figures 1 and 2.
NOTE: Pay attention to the path of the lift platform during operation. Make sure the lift does not rub
against or interfere with the vehicle in any way. If you notice any contact between the lift platform and
the vehicle, stop lift operation immediately and contact your authorized Pride Provider for assistance.
