6
GB
Code
Problem/cause
Solution
204
Calculation error
See the appropriate instructions in the user manual and repeat the
procedure
208
Excessive current
Contact an authorised Silverline service centre for assistance
220
Battery is low
Install new batteries (see ‘Installing the batteries’)
252
Meter gets too hot
Allow the device to cool. The optimal operating temperature is 0-40°C
253
Meter is too cold
Warm the device to the optimal operating temperature (0-40°C)
255
Measuring time is too long or the signal
received is too weak to make an accurate
calculation/measurement
Ensure a good reflective surface is used or a target plate and repeat the
appropriate measurement procedure
256
Signal received is too strong to make an
accurate calculation/measurement
The target to be measured is too reflective. Use a target plate or do not
aim at a strong light objective
261
The measurement target is out of range
Select a measurement point within the range limit (0.2-40m)
500
Hardware error symbol
Try switching the device ON and OFF several times. If the symbol is still
displayed on the LCD Screen, contact your authorised Silverline service
centre for assistance
Troubleshooting
727787_Z1MANPRO1.indd 6
27/04/2016 16:33
Summary of Contents for 727787
Page 7: ...www silverlinetools com 7 Laser Distance Meter 727787 727787_Z1MANPRO1 indd 7 27 04 2016 16 33...
Page 11: ...www silverlinetools com 11 T l m tre laser 727787 727787_Z1MANPRO1 indd 11 27 04 2016 16 33...
Page 28: ...Notes 727787_Z1MANPRO1 indd 28 27 04 2016 16 33...