EN
EN
Problem
Possible cause
Solution
No function when ON/OFF Trigger
Switch (3) is operated
No power
Check power supply
Defective ON/OFF Trigger Switch
Have the ON/OFF Trigger Switch replaced by an authorised Silverline service
centre
Slow material removal
Sanding sheet (8) too fine or worn
Fit new sanding sheet with coarser grit
Scratches on workpiece
after sanding
Sanding sheet too coarse
Fit new sanding sheet with finer grit
Not enough material removed
Continue sanding
Burn marks on workpiece
Sanding sheet incompatible with material
Fit correct sanding sheet
Too much pressure exerted on to the sander
Use less pressure whilst moving the tool
Excessive dust emission
Dust extraction not working; sanding sheet not aligned
with dust extraction holes in the Sanding Base Plate (10);
extraction holes blocked
Realign sanding sheet; unblock dust extraction holes
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
Troubleshooting
521333_OwnerManual.indd 10
521333_OwnerManual.indd 10
23/08/2021 13:03
23/08/2021 13:03
