Silvercrest STHL 2000 A1, Operating And Safety Instruction

Page: 16 / 150

GB/IE/NI/MT/CY 16
Press the lock
15
on the remote controller bat-
tery compartment
14
to the centre. Then, pull
the battery compartment
14
out (see Image 2).
Remove the used battery
16
.
Insert a new type CR2025 3 volt lithium coin
cell using the correct polarity.
Slide the battery compartment
14
back into the
remote controller until the lock
15
clicks into po-
sition.
6. Commissioning (Tower fan heater
with remote control)
6.1 Standby mode
Connect the Tower heater blower to an
earthed, secured wall mains socket. To
supply the appliance with electricity,
put the on/off switch 6 to position "I".
The appliance is then in standby mode
and the display 1 shows the room
temperature.
6.2 Fan mode
Press the on/off key 7 once in standby mode.
The appliance is then in fan mode.
6.3 Heating level setting (heating mode)
Press the heating level key
13
once in fan
mode. The appliance is then in heating
level 1. The tower heater blower has a
heat output of 1200 W. The on/off key
5 is lit in blue.
Press the heating level key
13
to change the
appliance to heating level 2. The tower heater
blower has a heat output of 2000 W. The on/
off key 5 is lit in red.
6.4 Switching the appliance off
Press the on/off key 7 once to switch the appli-
ance off. The fan runs for a further 60 seconds
before going off (a countdown is shown on
the display). The appliance returns to standby
mode. The display shows the room temperature.
To disconnect the towerheater blower from the
electricity, put the on/off switch 6 to position
"O".
6.5 Oscillation function
To switch the oscillation of the appliance
on or off, press the oscillation key
12
.
If successfully activated, the oscillation key icon
4 is lit.
The oscillation function has the effect that the air
blown off is distributed from the left to the right.
2