Silvercrest SKA 1000 A1, Operating Instructions Manual

Page: 29 / 35

■ 26
│
GB SKA 1000 A1
NOTE
► Thanks to the anti-drip function of this appliance, you can remove the vacu-
um flask
and pour coffee even during the brewing process. Make sure to
put the vacuum flask back into the device within 30 seconds, however.
2) Once the coffee has run through the appliance completely and no more
coffee is dripping into the vacuum flask , you will hear 6 acoustic signals.
The red control lamp BRÜHVORGANG
-
goes out and BREW is no longer
displayed.
NOTE
► You can use the AN/AUS button at any time to stop the brewing
process.
Pouring coffee
WARNING – RISK OF INJURY!
► Following the brewing process, a small amount of hot coffee may have
collected on the lid
of the vacuum flask . Carefully wipe the coffee
with an absorbent tissue before removing the vacuum flask from the
appliance.
1) Remove the vacuum flask from the appliance.
2) The lid is shut tight, the arrow on the handle points at the symbol.
3) To pour coffee, turn the lid a half turn until the arrow on the handle points
at the symbol. You can now pour coffee without the lid falling off.
4) Before placing the vacuum flask back in the appliance, turn the lid
back until the arrow points at the symbol again.
Timer function
You can set a scheduled time within a 24-hour period for the appliance to start
brewing coffee.
NOTE
► If you wish to use the timer function, ensure that the correct time has been
set (see chapter “Setting the time”).
1) Fill the appliance with ground coffee and water as described previously.
2) Press the AUTO/PROGRAMM button twice. The display 3 will read
PROG.
3) Repeatedly press the STD and MIN buttons to set the desired starting
time (see chapter “Setting the time”).