Silvercrest SKA 1000 A1, Operating Instructions Manual

Page: 28 / 35

GB
│
25 ■ SKA 1000 A1
Filling the appliance with water
WARNUNG - HEALTH HAZARD!
► Only use drinking water for your coffee!
The appliance lid is still open after adding the ground coffee.
1) Use the vacuum flask or another container to fill the water tank
!
with
water. Fill enough water for your desired amount of coffee into the water
tank
!
. Use the water level gauge on the water tank
!
for reference.
2) Place the vacuum flask into the device, making sure that the vacuum flask
lid is shut tight.
CAUTION – PROPERTY DAMAGE!
► Never fill more than 8 cups of water into the water tank ! (MAX mark).
► A small hole is located on the back of the appliance. It is a water overflow ,
which prevents excessive amounts of water from being filled into the machine.
If the water level exceeds the MAX mark, the water will escape through the
water overflow
onto the worktop.
► If the water tank
!
is full (8 cups of water) and the appliance is moved,
water may spill through the water overflow .
► Never fill the water tank with less than 2 cups of water ! . Use the water
level gauge on the water tank
!
.
3) Close the appliance lid .
NOTE
► During the brewing process, the amount of water decreases: some evapo-
rates, while the coffee grounds also retain some water. This is why the vol-
ume of coffee in the vacuum flask
will be slightly lower than the amount
of water you filled into the water tank
!
.
Initiating the brewing process
After you fill with the ground coffee and water:
WARNING – RISK OF INJURY!
► Never open the appliance lid while brewing is in progress! Bursts of hot
steam may be released. Risk of scalding!
1) Press the AN/AUS button . The red control lamp BRÜHVORGANG - will
light up and the display
3
will read BREW. The appliance will start brewing.