Silvercrest SHSS 16 A1, Operating Instructions Manual

Page: 46 / 64

SHSS 16 A1 GB
│
MT
│
43 ■
Operation
ATTENTION! PROPERTY DAMAGE!
► The suction opening must always be open
and may not be blocked. Blockages lead to
overheating and damage to the motor.
► Do not vacuum shag pile carpet with the floor
nozzle. The rotary brush
0
can get caught in
the carpet and block!
NOTE
► Make sure that the HEPA filter and the
coarse filter are always inserted before
using the appliance.
► As soon as the suction power of the appliance
begins to diminish noticeably and the charge
indicator lamp
flashes green, connect the
appliance to the charger
,
.
Using the hand element with the
handle
1) Insert the hand element into the hand
element recess
.
as described in the chapter
"Assembly/disassembly".
2) Fold out the grip
-
on the handle by pressing
the release button
3
and, at the same time,
pulling the grip
-
upwards.
3) Switch on the appliance using the On/Off
switch . The charge indicator lamp
lights up green, the LED light
6
on the floor
nozzle lights up and the rotary brush 0 starts
turning.
NOTE
► Press the ECO button to switch to the
energy-saving ECO mode. The appliance
now uses a lower suction power but can run
for longer.
Press the ECO button
again to work at full
suction power.
4) Guide the floor nozzle over the area to be
vacuumed. Hold the grip
-
so that the floor
nozzle moves smoothly over the floor.
5) Press the On/Off switch when you have
finished vacuuming. The rotary brush
0
stops,
the charge indicator lamp and the LED
light
6
go out.
Using the hand element
1) Remove the hand element from the hand
element recess . as described in the chapter
"Assembly/disassembly".
2) If required, you can attach the crevice tool
%
,
the brush attachment 1 or the upholstery
nozzle + .
3) Press the On/Off switch on the hand
element to start vacuuming the desired
areas. The charge indicator lamp lights
up during operation.
4) When you are finished vacuuming, press the
On/Off switch again. The charge
indicator lamp goes out.
Cleaning and maintenance
WARNING! RISK OF INJURY!
► Always unplug the charger , from the
mains. Pull the barrel plug out of the
charging socket
"
on the cradle
#
before
cleaning the cradle
#
.
► Always remove the hand element from the
hand element recess
.
on the handle before
cleaning
-- the hand element
,
-- the handle or
-- the rotary brush
0 .
ATTENTION! PROPERTY DAMAGE!
► Do not use abrasive or aggressive cleaning
materials. These can damage the surface of
the appliance!
NOTE
► The LED light 6 is maintenance-free.
The LEDs cannot be changed!