Silvercrest SFE 450 D2, Operating Instructions Manual

Page: 13 / 110

11
GB
Emptying the pulp container
• The pulp container | 16 must be emptied
when it is full. Check the filling level
from time to time, e.g. when emptying
the micro-mesh strainer
| 4 .
• To empty the pulp container | 16 :
- Turn the on/off switch | 14 to 0 .
- Pull out the mains plug | 8 .
- Wait until the micro-mesh strainer | 4
has come to a standstill.
- Open the safety catches | 15 .
- Remove the lid | 18 .
- Tilt the pulp container | 16 slightly, re-
move it and empty it.
- Reassemble the parts and proceed
with juice extraction.
8. Cleaning and storing
Clean the device before the first use
and after every subsequent use!
DANGER! Risk of electric
shock through moisture !
~
The motor block | 7 , the power cable
and the mains plug | 8 must not be im-
mersed in water or any other liquids.
~
Disconnect the mains plug | 8 from the
wall socket, …
- before assembling or disassembling
the device and
- before you clean the device.
DANGER! Risk of injury from
cutting
~
The small blades | 17 at the bottom of
the micro-mesh strainer | 4 are sharp.
Please be very careful when handling
them. When cleaning by hand, please
use the provided cleaning brush
| 12 .
WARNING! Risk of material dam-
age!
~
Please be careful not to damage the mi-
cro-mesh strainer
| 4 . Do not apply to
much pressure to the micro-mesh strain-
er surfaces.
~
No part of the device may be cleaned
with boiling water.
~
Please clean all parts immediately after
use. In this way, you can prevent the
fruit residues from drying on the device
and causing possible blockage (e.g. of
the screen).
~
Do not use any astringent or abrasive
cleaning agents.
__CPE284970_Fruchtentsafter_B4.book Seite 11 Donnerstag, 1. Dezember 2016 8:35 20