SBTF 10 D4
■
46
│
GB
│
IE
Changing the fuse in the car charger adapter
There is a fuse in the car charger adapter to protect the
vehicle‘s on-board power supply. If the device no longer
works, check the fuse and replace if necessary.
♦
Open the car charger adapter by turning the screw
insert (C) carefully anticlockwise with a pair of pliers
and carefully removing it.
♦
Remove the plug tip (B) from the fuse (A) and pull out
the fuse.
♦
Now insert a new type F2AL 250 V fuse into the car
charger adapter , fit the plug tip (B) onto the slightly
protruding end of the fuse and screw the previously
removed screw insert (C) back in.
DANGER
►
Replace the fuse only with another of the same type.
Fuses with a different rating could cause a fire.
NOTE
►
If the device still does not work or the fuse blows
again immediately, the device is defective. In this
case, please contact the Service Hotline (see section
"Service").
Summary of Contents for SBTF 10 D4
Page 10: ......
