Silvercrest LT 1510, User Manual And Service Information

Page: 167 / 244

20
Signal Source “DTV” (Digital TV Reception)
Signal Source “DTV” (Digital TV Reception)
The built-in receiver allows you to watch terrestrial digital TV shows via an outdoor or indoor antenna
as well as digital TV shows from the cable TV network. Furthermore, the “DTV“ (Digital TV) mode
also allows you to receive digital radio broadcasting stations. To do this, connect the correspond -
ing antenna cable to the RF input (see page 10, item 14) on the right panel of your LT 1510. When
using the device for the first time you must program the channels or perform an automatic channel
search.
Automatic Digital Channel Search
With automatic digital channel search, your LT 1510 will store all available digital channels. In order
for the digital channel search to work properly, the signal source “DTV” must be selected (see page
19 - Selecting the Signal Source). Proceed as follows:
1. Press the
INPUT button (30) on the remote control. The signal source selection menu will ap-
pear. Press the direction buttons (32) to select the signal source “DTV”.
2. Press the MENU button (50) on the remote control to display the TV settings menu.
3. Press the direction button

(32) on the remote control three times to navigate to the “DTV”
option and press

to open it.
4. Press the direction button

(32) on the remote control to navigate to the "Auto Tuning" option
and press

to open it.
5. Select “Yes” and press OK on the remote control to launch the automatic channel search.
A window will display the current frequency band. A progress bar will inform you of the status of the
automatic channel search. All found stations will be automatically stored in a sequential list of chan-
nel presets.
After the search of the entire frequency band is completed, you’re done. Then the first-found chan -
nel will be tuned-in. To cancel the process at any time, press MENU (50) on the remote control.
If you had already performed an automatic channel search in the past, all existing pre-
set channels will be replaced by the new ones found.
Setup Menu for Signal Source “DTV”
The setup menu lets you perform specific settings to customise the LT 1510 according to technical and
personal requirements. Press the MENU button (50) to open the setup menu. The menu is divided into
four items allowing you to adjust or change picture, sound, system preferences and channel settings.