Silvercrest DP-5300 Series, User Manual And Service Information

Page: 14 / 43

Introduction
11
Remote control
The DVD player is supplied with a remote control
unit and the corresponding batteries. For a detailed
description of the button layout, see the fold-out
cover page of this User’s Manual.
Using the Remote Control
Your Silvercrest DVD player can be comfortably
controlled via the supplied remote control unit.
Point the remote control to the sensor at the front
panel of the DVD player. Do not exceed an angle
of 30 degrees for optimum results.
Note:
Any obstacles between the remote control and the
sensor window can deteriorate the remote control
response.
Also similar remote control units (using
the same signal codes) can interfere with the DVD
player functionality or execute an undesired
function.
Do not store the remote control upside down, and
do not place any objects on it to avoid accidentally
pressing a key and the consequent battery drain.
Cautions When Using the Remote
Control
Do not expose the remote control to any shock or
vibrations, and do not splash any liquids over the
remote control. Do not store it in a humid place.
Do not place the remote control under direct
sunlight as its heat may deform the remote control.
The remote control may not work properly when
the sensor window is exposed to sunlight. In such
a case, put the remote control closer to the sensor
window or change the angle of the light source or
of the unit.
Notes on Batteries
When left unused for a long period of time, it is
recommended that you remove the batteries from the
unit.
Do not use batteries other than those specified.
Inadequate handling of the batteries can lead to
chemical leakage and/or explosion.
If a battery leaks, remove it from the remote control
and avoid any contact with the leaked liquid. Clean
the battery compartment well before inserting new
batteries. We recommend using protective gloves.
Inserting the Batteries
If you have just purchased the device or if the
remote control only works at very short distances,
you must insert or replace the batteries. In this
case, insert two new batteries type AAA 1.5 V into
the remote control.
To replace the remote control batteries, you must
remove the battery compartment cover. When
inserting the batteries, make sure that the polarity
matches. On the battery and in the battery
compartment there are the corresponding
markings.