Silvercrest 90255, User Manual And Service Information

Page: 106 / 114

SilverCrest SFB 10.1 C3
104 - English
10. Press to confirm your entry. The display reads “OK” and then
returns to the start window.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
The learn function (LEARNING)
Programming via the learn function (LEARN KEY)
This function allows the remote control to learn individual buttons for a
selected device.
1. Press the device button for the device that you wish to program.
2. Press and hold the button for 3 seconds.
3. Press , select “LEARNING” and press to confirm.
4. Press , select “LEARN KEY” and press to confirm.
5. The display reads “SELECT KEY”.
All buttons except the device buttons support learning.
6. Press the button that you wish to learn a command. The display
reads “WAITING”.
7. Place the original remote control so its IR LED and the IR LED (2) of
your 10-in-1 remote control face each other and are no greater than
5 cm apart.
8. Next press the button on the original remote control from which you
wish to copy the signal. The successful detection of the button code is
indicated by “SUCCESS” on the display.
9. Repeat steps 5 to 8 for each button that you wish to learn a function.
10. If the transmission of the original code fails or no code is sent during
the next 30 seconds, “FAIL” appears on the display. In this case,
repeat steps 5 to 8.
You can quit learning mode by pressing the button if the display
reads “SELECT KEY”. Pressing any of the device buttons takes you back
to the start window.
If you experience any problems with the learn function, the
batteries of the original remote control could be low.
Replace them if necessary.
Deleting individual button codes (DELETE KEY)
This function allows you to delete the learned code for an individual
button for a selected device.
1. Press the device button for the device that you wish to program.
2. Press and hold the button for 3 seconds.
3. Press , select “LEARNING” and press to confirm.
4. Press , select “DELETE KEY” and press to confirm.
5. The display reads “SELECT KEY”.
6. Press the button for which you want to delete the code. The display
reads “SURE DELET”.