Silvercrest 90255, User Manual And Service Information

Page: 100 / 114

SilverCrest SFB 10.1 C3
98 - English
characters for a brand name. If you make a mistake, press to
delete the last character and enter it again.
7. Typically, different device manufacturers use different codes for their
remote controls. At this point you’ll have to find the optimum code.
The current code is shown under the selected brand name. You can
press the buttons to select the preset codes for the desired
brand.
8. Now test the code selected by pointing the remote control at the
device and checking if it responds properly to the button pressed . It
is not necessary to exit the setup mode to perform this test.
The following buttons cannot be used for the function test:

, , ,

the device buttons (4)

the numeric keypad (11)
9. If most of the buttons work properly, press . The code is saved for
the device button selected .
10. If no buttons work properly or only a few do, press to select the
next code and repeat the test as described in step 8. Repeat this
procedure as many times as necessary until you have found suitable
code.
Press to go back one menu level. To return to the start window,
press one of the device buttons.
Repeat the above procedure for all devices you wish to control with your
new remote control.
Automatic code search (AUTO SRCH)
1. Press and hold the button for 3 seconds.
2. Press , select “CODE SETUP” and then press . Press
and select “AUTO SRCH”. Press .
3. Press the device button for the device you wish to program. Then
press . The remote control starts sending all available codes. This
is indicated by a flashing IR icon on the display.
By default the remote control sends the code for the button.
If no code is assigned to the button, the following codes will be
send for the different devices:

TV:
the remote control sends the code
“CH+” .

DVD/CD/VCR:
the remote control sends the code
“PLAY” .

DSAT/CBL:
the remote control sends the code
“CH+” .

AMP:
the remote control sends the code
“MUTE” .

Other devices:
the remote control sends the code
“CH+” .
4. If your device responds to the sent code by powering on or off or by
executing one of the above functions, press to stop the
search. At this point you are close to the correct code, but you may
not yet have found the one that matches completely, as the