17
SEM 1100 A2
GB
CY
2) Dissolve 2 tablespoons (about 30 grams) of citric acid (available in drug-
stores or chemists) into the water.
3) Replace the water tank
1
into the appliance.
4) Switch the appliance on with the on/off switch
3
. The rotary switch
5
must
be in the position “
”. The steam control knob
2
is closed.
5) Insert the sieve carrier
w
, without either of the espresso sieves
0
/
q
, into the
appliance and place a cup under the sieve carrier
w
. As soon as the green
heating-up control lamp
4
glows, turn the rotary switch
5
to the position “
”.
6) Let about 2 cups (coff ee cups) of water pass through and then stop the process.
7) Hold a container under the milk frother
z
.
8) Place the rotary switch
5
at the position “
” and wait until the green heat-
ing-up control lamp
4
glows. Slowly turn the steam control knob
2
to the
position “+ “. Allow the appliance to create steam for about 2 minutes.
9) After 2 minutes close the steam control knob
2
, set the rotary switch
5
to the
position “
” and switch the appliance off .
10) Let the scaling agent take eff ect for about 15 minutes.
11) Repeat the steps 4 - 10 three times.
12) Then place the rotary switch
5
at the position “
” and let the solution fl ow
through until the water tank
1
is empty.
13) Rinse the water tank
1
with clean water and then fi ll it with clean water up
to the MAX marking.
14) Turn the rotary switch
5
to the position “
” as soon as the green heating-
up control lamp
4
glows.
15) Allow the water to run through.
16) Repeat the steps 13 - 15 three times.
17) Fill the water tank
1
with water once again.
18) Turn the rotary switch
5
to the position “
”.
19) Hold a container under the milk frother
z
and slowly rotate the steam control
knob
2
to the position “+” as soon as the green heating-up control lamp
4
glows.
20) After about 1 minute close the steam control knob
2
, set the rotary switch
5
to the position “
” and switch the appliance off .
NOTICE
►
After 3 minutes the appliance will switch itself off automatically.
