■
12
│
GB
│
IE
SAST 18 A1
Operation
ATTENTION! PROPERTY DAMAGE!
►
The suction opening must always be open and may not be blocked.
Blockages lead to overheating and damage to the motor.
►
Use the wet-suction nozzle
5
only at level I (low/wet suction
).
NOTES
►
Make certain that the HEPA filter
z
is inserted before using the appliance.
►
When vacuuming liquid, do not exceed the MAX marking in the dirt
container
i
.
►
If the motorised brush attachment
6
is blocked so that the brush
can no
longer turn, the charge indicator lamp
w
flashes red after approx. 15 seconds
of the blockage, the working light
t
goes out and the appliance stops
vacuuming. If this happens, remove the blockage as described in the section
“Cleaning the brush attachment”. Slide the On/Off switch
q
to the “OFF”
position. To restart the appliance, slide the On/Off switch
q
to position I
or II.
1) Remove the appliance from the wall bracket
7
or, if you are not using the
wall bracket
7
, remove the barrel plug
9
from the socket.
2) If required, place the appropriate nozzle in the suction opening. See section
“Using accessories”.
3) To switch the appliance on, slide the On/Off switch
q
forwards into
position I (= low power/wet suction
) or position II (= high power).
The charge indicator lamp
w
lights up yellow at level I, green at level II.
The working light
t
lights up.
4) To switch the appliance off, place the On/Off switch
q
back to the “OFF”
position. All lamps go out.
NOTE
►
After you have vacuumed up liquids, clean the dirt container
i
immediately. Otherwise, bacteria or mould will build up inside! Ensure that
the HEPA filter
z
is completely dry before using the appliance again.
