GB
│
IE
│
NI
│
CY
│
7
■
SPM 220 A1
Assembling the appliance
NOTE
►
Before first use, clean all parts of the appliance
as described in the section
Cleaning
.
1) Set up the appliance on a flat surface near a
mains socket that is easily accessible. There
should be enough space in front of the appli-
ance for a bowl or similar to catch the pasta.
2) Push the dough container
t
into the appliance
base
5
as far as the stop. The tabs on the
dough container
t
must be pushed into the
corresponding slots in the rear wall.
3) Guide the kneading hook
9
into the dough
container
t
from above and insert it into the
drive shaft
6
.
4) Push the support
q
into the end of the
bracket
w
so that the three tabs on the
support
q
slide into the grooves on the
bracket
w
(
fig. 3
).
0
q
w
9
Fig. 3
5) Mount the bracket
w
onto the dough
container
t
. Push in the bracket
w
so that its
narrow end goes through the round opening
on the dough container
t
(
fig. 3
).
The bracket
w
only fits into the opening in one
position; the marking
e
must point towards
the
symbol on the dough container
t
.
Turn the bracket
w
clockwise until the
marking
e
on the bracket
w
points to the
symbol (
fig. 4
):
w
e
Fig. 4
6) Then push the dough shaft
0
with its narrow
end through the bracket
w
into the retainer
on the kneading hook
9
(
fig. 3
). If necessary,
reach into the dough container
t
from above
and wiggle the kneading hook
9
a little until
you can push in the dough shaft
0
.
7) Place the front panel
z
onto the dough
container
t
and push it firmly into place. The
catches on the front panel
z
must slide into in
the corresponding recesses on the dough
container
t
.
8) Select the appropriate shaping disc
8
(see
section
Shaping discs
) and slide it onto the
bracket
w
so that the two catches on the
shaping disc
8
slide into the recesses on the
bracket
w
.
9) Push the shaping disc fixture
r
onto the
bracket
w
and tighten it by turning it clockwise
towards the symbol. Fix the shaping disc
8
in place with your free hand if necessary.
10) Do not fit the lid
2
until after you have placed
the required amount of flour in the dough
container
t
(see section
Making pasta
).
11) Insert the plug into an easily accessible mains
socket. You will hear a beep and the display
a
lights up briefly. The appliance is now in
standby mode.
The appliance is now assembled and ready for
operation.
IB_385824_SPM220A1_LB6-.indb 7
14.10.2021 09:11:06
Summary of Contents for 385824 2107
Page 3: ......